Please ensure Javascript is enabled for purposes of website accessibility

Electrical Design & Engineering Services – Embedded Hardware Design Services – D&K Engineering

Speak with an Expert

In complex products, embedded computer hardware and electrical systems must meet rigorous standards to withstand a wide range of operational environments and use cases. Our embedded hardware design services, and our electrical engineering services, efficiently deliver custom printed circuit board assemblies and related components and systems to meet our clients’ most demanding requirements.

D&K’s multidisciplinary team has decades of experience developing analog and digital hardware solutions for our clients. Our electrical design services and expertise includes microprocessor/microcontroller/DSP/PLC based design, FPGA design, RF/Analog design, and more. From design through layout to a tested and verified PCBA, our team of electrical engineers and circuit designers rapidly and efficiently deliver custom electrical and hardware design service solutions for our clients’ most demanding requirements.

  • Electrical and Electronic System Architecture
  • Printed Circuit Board and Flex Circuit Design and Layout
  • Thermal Analysis
  • Signal Integrity
  • Design for Cost/Obsolescence/Manufacturability/Testability
  • EMC/EMI compliance

Analog and RF Design Expertise

  • Active & passive filtering
  • Precision amplifiers and receivers
  • A/D & DA conversion – high resolution/speed
  • Motor drive & control
  • Low power/noise circuits
  • High current/voltage circuits
  • Linear & Switching Power Supplies
  • Mixers, VCOs and PLLs
  • Cameras, sensors and sensor interfaces
  • Optical and imaging devices & interfaces
  • Battery Management
  • RF design and module integration including RFID, Bluetooth, ZigBee, 802.X, and GPS, GSM, CDMA, UMTS, HSPA and LTE (2G, 3G, 4G) modems
  • Digital Design Expertise
  • Digital filter design and filter modeling
  • Digital signal processing
  • Microprocessor and Microcontroller design – Intel, Texas Instruments, NXP/Freescale, Microchip/Atmel, ST Microsystems, Renesas, Silicon Labs
  • Memory interfaces SDRAM DDR, DDR2, DDR3, QDR SRAM, FLASH
  • Communication interfaces & protocols – LVDS, HSTL, SSTL, USB, SPI, I2C, RS-232/422/485, Serial ATA, CAN Bus, PCI-X, PCI-e, Gigabit Ethernet,
  • Laser, CMOS & CCD Imaging & scanning system development

FPGA Development

  • System architecture
  • VHDL/Verilog coding
  • Timing analysis
  • Test bench development
  • IP integration – Embedded processors (Nios, ARM, etc.) I/O interfaces & Protocols (PCIe, USB, etc.)
  • Altera Stratix, Arria, Cyclone, Max including IP Xilinx Spartan, Virtex, Zynq, Kintex, Artix
    Cypress PSoc devices


  • Altium
  • Quartus
  • ModelSim
  • Vivado
  • ISE
  • OrCAD
  • PADS PowerPCB

D&K Engineering, a leading provider of electrical engineering services, is able to assist you in all your need for embedded hardware design services. Contact us today to speak to one of our experts or to request a quote.